enRoute is relatively new electronic, but is working
to develop and produce better esc’s, brushless motors, and accessories
for RC cars; whether for TC Racing or RC Drifting application. enRoute
products are engineered to exceed your expectations for design and
performance. During their introduction of these electronic systems in
late 2011, their entire line of products were always sold out due to
the high demand. They are finally back in stock for the 2012 year, so
get them while they last.
The enRoute Motor and ESC product line is as follows.
XR Sensor-less Brushless Motors
A sensor-less type brushless 540 size motor. Nothing fancy, just the typical high performance brushless motor.
A sensor type brushless 540 size motor with adjustable timing. This is
a high performance brushless motor made for RC racing and drifting
applications. This motor is JMRCA approved for modified stock class
racing. The combination of small diameter rotor increases the kV rating
and produces more power. The trade-off is a minor loss in efficiency
and torque, but greater power delivery.
YR-S Brushless Sensor Brushless Motor
A sensor type brushless 540 size motor with adjustable timing. This
motor is mild in nature and is easy for beginners starting into
brushless motors. For anyone seeking a high powered application the
XR-S line of motors are recommended. Available from 8.5T to 13.5T.
JXR Crobi 3 ESC
The Crobi 3 is designed for both sensor and sensor-less brushless
motors. The low loss FET is utilized as a better medium for better
power management, which results in better performance and smoother
control. The Crobi 3 ESC can be used for racing or drifting
applications, it is very capable in high load applications. There are
also special programs on the Crobi 3 ESC for best match to ZR-s/XR-s
series of sensor motors. This ESC is also capable of boost or turbo
mode. enRoute warns that if boost or turbo modes are utilized, then it
must be used with an enRoute motor, otherwise the product warranty will
be void.
Specifications:
To change the setting, a separate program for CROBI 3 card is required
Motor support: 17.5T from ZR-s/XR-s3.5T with sensors, Proton series
(compatible with proper load range. Or overload, such as fuel,
throttle-intensive work, not made sufficient cooling of the ESC may
work in a protected situation)
Compatible Battery: NiMH4-9 cell / Lipo2-3 cells
Output BEC: 6V/3A
Size: 40mm (L) x 37mm (W) x 34mm (H) excluding protrusions Weight: 98g
Program Card for Crobi 3
Optional CROBI special ESC program card sold separately
NEON and traditional, are not compatible with the XRE series
The program card allow configuration for the follow settings.
1. Cut-off voltage:
2. Mode:
3. Motor timing
4. Adjustment punch:
5. Back Power:
6. Throttle limit:
7. Braking rate:
8. Drag Brake
09. Motor direction of rotation:
10. Neutral Range:
11. Turbo Timing:
12. Rpm boost start:
13. Turbo delay:
